2006 Ford Focus ST225

Because the front subframe has been removed during the clutch replacement, the car needed an alignment. The document shows the final values while...

I had to weld the mount back on as it broke off. It's not the prettiest weld, but it will hold for sure.

Since the car is going to be tuned and was still running on the factory clutch, I decided it was worth investing in an RS clutch kit. I’d already...

The new frame has arrived. After a few modifications, I was able to install the device. It works fine, except for the camera, for which we need to...

I am quite unlucky with this head unit install. The new frame arrived broken from China, and it did not fit the factory enclosure very well. I...

The target for today was to install a Chinese Android head unit with a reverse camera. The car didn't have parking sensors at the rear, so the...

I have swapped all the traditional halogen bulbs in the interior for LED bulbs. It looks much better. I had some CAN bus bulbs that caused the...

The timing belt and water pump were last replaced at the Ford dealership at 90,000 km, but that was already 8 years ago. I have decided to replace...

The interior really needed a deep clean; it was full of small rocks and dust everywhere. Some before-and-after photos are attached.